PSNOOK Wearable Urinal Collector Installation & Use Guide

Before Setup

• Inspect the collector, garment fastenings, tube, and collection bag.
• Prepare the garment adjustment and bag support arrangement.
• Keep the bag outlet closed before collection.

Installation Steps

1. Identify this kit's components

   This variant uses a rounded cup-shaped collector. The kit also contains adjustable support briefs, an approximately 39-inch connecting tube, and separate 1000 mL and 2000 mL bags. The collector sits outside the body; the briefs support its position while the tube carries urine to the selected bag.

2. Position the briefs and external collector

   Open the waist hook-and-loop fastening and loosen the buttoned elastic support straps. Arrange the briefs around the waist with the collector at the front and its outlet pointing downward. Position the collector externally according to the wearer's fitting instructions, then close the waist fastening.

3. Adjust the garment supports

   The elastic support straps have a row of buttonholes. Select the buttonhole that supports the garment and fasten it onto the button; adjust the waist hook-and-loop overlap separately. Check that the briefs support the collector without pulling it out of position or overtightening the straps.

4. Connect the collection path

   Connect the supplied tube between the collector's lower outlet and the inlet of the selected collection bag. The bag's lower T-valve is its emptying outlet, not the tube inlet. Check that the connections are seated and the tube is not twisted, pinched, or pulling on the collector. Use the bag support arrangement specified in the product and care instructions.

5. Operate the bag's sliding T-valve

   The blue cross-piece slides sideways to open and close the outlet. Keep the outlet closed for collection. For emptying, direct the outlet into the intended receptacle and slide the cross-piece to open the flow. Slide it back to close the outlet when finished. Follow the component hygiene instructions when handling the outlet.

6. Recheck the arrangement

   After fitting or repositioning, check collector position, garment fastenings, tube connections, and the closed bag outlet. Follow the individual checking, emptying, and hygiene routine.

After Setup Checks

• Check collector position and garment support.
• Check that tube connections are seated and the tube runs freely.
• Keep the bag outlet accessible for emptying.
• Check the connections and closed outlet for leakage.

During Use Checks

• Recheck the collector and tube after posture or garment changes.
• Follow the individual checking, emptying, and hygiene routine.

When to Adjust or Remove

• Stop and review the arrangement if leakage, poor collection, discomfort, or skin changes occur.
• Replace a cracked collector, damaged tube, faulty fastening, or leaking bag.

Daily Inspection

• Inspect the collector, tube connections, garment fastenings, bag, and outlet valve.
• Follow the component-specific cleaning, drying, and replacement instructions.
• Check all connections again after reassembly.